www.johnsonsystems.com 11
15. FIRMWARE View the rmware version running on the CS-IPRO microcontroller.
VER X.X
VER X.X Indicates the rmware version running on the CS-IPRO microcontroller.
16. SERIAL # View the CS-IPRO unique six-character silicone serial number.
XXXXXX
XXXXXX Indicates the CS-IPRO unique six-character silicone serial number.
17. BATTERY View the battery voltage level and status.
The batteries should be replaced when a low (LOW) battery voltage level is
detected. Once the batteries are at a critical (CRIT) voltage level, the CS-IPRO will
automatically save the DMX channel patch data and power down after 5 seconds.
3.0 OKAY The bottom line indicates the battery voltage level (3.0) and status (OKAY).
2.2 LOW Indicates a low (LOW) battery voltage level between 2.2 and 2.1 VDC.
2.2 CRIT Indicates a critical (CRIT) battery voltage level of less than 2.1 VDC.
18. PRINTOUT Print the DMX channel patch for a selected slider or all sliders.
PATCH Prints out the DMX channel patch saved in the CS-IPRO memory only.
TThe CS-IPRO is capable of printing out the DMX channel patch for a selected slider
(01 to 12), or all (ALL) of the sliders at once.
Point the CS-IPRO infrared LED window directly at the hand-held printer (Johnson
System Inc., Part Number: JS-IP) infrared LED window, within 6' (1.8 m).
PRINTOUT Press EXECUTE to enter the menu.
SS>01 Indicates the selected slider (SS) number (01) to printout.
SS>ALL Press MENU ( ) to select the slider number from 01 to 12 or ALL to print.
PRINTING Press EXECUTE to printout the DMX channel patch for the selected slider(s).
DONE !!! Displayed briey to indicate data has been sent to the hand-held printer.
Press ESCAPE to exit the menu.
19. LCD VIEW Adjust the contrast of the LCD Display for optimum viewing.
ADJUST
LCD VIEW Press EXECUTE to enter the menu.
ADJUST Press MENU ( ) to adjust the LCD contrast.
Press ESCAPE to exit the menu.
Typical Application Procedures
1. Congure the DMX channel patch for a CS-DMX control station from scratch.
A) CLEAR PATCH be sure the DMX channel patch data is cleared (blank) in the CS-IPRO.
B) EDIT PATCH edit and congure the DMX channel patch for each slider as required.
C) CHECK PATCH conrm the DMX channel patch is correct for each slider. EDIT PATCH again if
corrections are required.
D) SET CS PATCH load the DMX channel patch into the CS-DMX control station.
E) SAVE PATCH save (backup) the DMX channel patch into the EEPROM memory module.
2. Edit the DMX channel patch for a CS-DMX control station.
A) GET CS PATCH load the DMX channel patch from the CS-DMX control station into the CS-IPRO.
B) EDIT PATCH edit and recongure the DMX channel patch for each slider as required.
C) CHECK PATCH conrm the DMX channel patch is correct for each slider. EDIT PATCH again if
corrections are required.
D) SET CS PATCH load the edited DMX channel patch into the CS-DMX control station.
E) SAVE PATCH save (backup) the DMX channel patch into the EEPROM memory module.
X.X OKAY
(40 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels